Safety configuration file
MiR1200 Pallet Jack is set up with the following safety configuration:
- SICK configuration file : MiR1200 Pallet Jack SICK configuration HWx.x V6.0.5
- Minimum supported software version : MiR Fleet Enterprise 1.2.0
Each configuration in the safety configuration file generates a checksum. The checksum will change if any modifications are made to the configuration.
The configuration file on your robot has the following checksums.
| Component | Checksum |
|---|---|
| Safety PLC | 0x60998570 |
| Rear scanner function and network | 0xD824DC9 |
| Rear scanner function | 0xBF2C8D4B |
| Front right scanner function and network | 0xBA96461D |
| Front right scanner function | 0xCBBA6E74 |
| Front left scanner function and network | 0x58710226 |
| Front left scanner function | 0xCF825C75 |
Checking the checksum
If you want to verify that the safety configuration file has not been modified, you can compare the current checksums. You will need to install the latest version of SICK's Safety Designer software to see the checksums.
To find the current checksums, follow these steps:
Connect to your robot's network as described in Connect to the web-interface.
Open SICK Safety Designer.
Select Search for devices.
Drag all devices from the Device search window to the corresponding device in the Device overview window.
When you are prompted to upload to the safety PLC, select No.
You can now read the current checksum values for each device configuration. If the values differ from the ones in Table 7.1, the safety configuration file has been modified from the original.
